This dash may is made for the following Land Rovers. This cover is made of high quality leather look vinyl. Cover will install in 30-45 minutes with minimal tools or mechanical know how. You will need to have an upholstery shop.
Install it if you are not a diyer. This cover will need to be glued on and tucked behind the dash vents, gauge cluster, a pillars and GPS screen if equipped. There are a total of 4 screws to remove on cars without navigation and 8 screws on cars with GPS. This is not a hard molded piece of cheap abs plastic, this project took some time to develop to insure a OEM fit and finish.We give this product a 8 out of 10 in difficulty. Remove both driver and passenger dash bezels. One houses the light switches (unplug switch) and the other cup holder. All three will pop off, just pull from the bottom and pull down a bit. Remove the center speaker cover also will pop off.
Remove both A pillar covers. Torx Screws are behind the srs cap.
If you have a navigation screen make sure to remove the 4 Phillips head bolts attaching it to the dash. There is no reason to unplug and remove but it will make things easier. Pop off the top clam shell from steering wheel column. Pull down the lower knee cover and pull off.You will see two small torx screws attaching the column accordion slide. Pull off and lower steering wheel all the way down. Remove huge cluster by removing the two torx screws and unplug. Pop off the two side defrost vents on either side of the dash. Make sure to use acetone (nail polish remover) thinner or mi neral spirits to clean the dash from any contaminates. Now you can lay the dash cover on and center it using the gauge cluster hump. Once its centered you can start the adhesion process. We like to use a standard super glue liquid (not the gel) add a small amount of glue to the underside of the cover that goes around the cluster hump. Once thats set you can use as much or as little glue as you like around the back side by the windshield and around the front side. We leave enough material in the front so it can be trimmed and glued behind the vents and center gps area. We like to slice the dash panel along the sides to slow the trimmed cover to be tucked in. As well and right above the glove box shelf area. The item "Land Rover Lr3/ Discovery 3, Range Rover Sport Dash Cover, Dash Mat" is in sale since Tuesday, December 11, 2018. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Interior\Dash Parts". The seller is "rovagear" and is located in San Antonio, Texas.
This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Israel, Mexico, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica, Antigua and barbuda, Aruba, Belize, Dominica, Grenada, Saint kitts and nevis, Saint lucia, Montserrat, Turks and caicos islands, Barbados, Bangladesh, Bermuda, Bolivia, Ecuador, Egypt, French guiana, Gibraltar, Guadeloupe, Iceland, Jordan, Cambodia, Cayman islands, Sri lanka, Luxembourg, Monaco, Macao, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Brunei darussalam, Guernsey, Jersey, Liechtenstein, Martinique, Russian federation.